I was wondering if it is possible to use a RTD instead of a thermocouple with this chip or are there other chips available able to do the same job as the ADS1118 but with a RTD. Thanks for ...

This thread has been locked. If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this ...

static __INLINE void NVIC_EnableIRQ(IRQn_Type IRQn) { NVIC->ISER[((uint32_t)(IRQn) >> 5)] = (1 << ((uint32_t)(IRQn) & 0x1F)); /* enable interrupt */ } Calling the ...

Uploads a binary file to the Flash memory, via SPI, then clears the flag and resets Makes the jump to the aplication uint32_t transferAddress; // Address that is ...

I am using ADS1263EVM-PDK. I want to measure current using differential input, voltage across shunt resistor( 1 ohm) . used INA0 and INA1 . i am using GUI tool. the full scale voltage is 5 v , taking ...

I want to use the DTC function of the UCD7138, which is controlled by the UCD3138A, so I need to customize the UCD3138FW_LLC firmware. I would like to add an interrupt process when the CIMINT_ALL_DTC ...

I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this. here is our pin definition ...

I am using TMS320F28335 DSP for Power electronic application. Following are the scenarios when PWM output is undesired (Short duration pulses): 1. During power on/off cycle. 2. When Power supply ...

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.

When the Init bit (CCCR.INIT) is cleared by your code, the MCAN module will then wait for 129 occurrences of Bus Idle (129 × 11 consecutive recessive bits) before ...

I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...