I was wondering if it is possible to use a RTD instead of a thermocouple with this chip or are there other chips available able to do the same job as the ADS1118 but with a RTD. Thanks for ...

The following problems occur in the BQ34Z100 demo test. 1. During the discharge process at 0℃ 1C, the SoC jumps directly from 100% to 0%, and the capacity almost becomes 0. The parameters are as ...

I've successfully configured the BQ76942 in my system and everything seems to be working fine. I've done this development using the EV2400. I would now like to OTP the part using the EV2400. I've ...

I am using ADS1263EVM-PDK. I want to measure current using differential input, voltage across shunt resistor( 1 ohm) . used INA0 and INA1 . i am using GUI tool. the full scale voltage is 5 v , taking ...

I am using PIC32MZ2064DAS169i micro controller with DP83848 PHY. I have interfaced the DP83848 PHY driver library in MPLAB version 6.20 harmony library. When i am ...

I read the result register for current measurement 1000 times. I found that I got negative value(unit: V), but it shouldn't be like this. here is our pin definition ...

Uploads a binary file to the Flash memory, via SPI, then clears the flag and resets Makes the jump to the aplication uint32_t transferAddress; // Address that is ...

But why does this document mention uniflash also can be used on PC side? This make the reader confused.

I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

I have take a look to the following TI documents C2000 F28P65x Series LaunchPad Development Kit TMS320F28P65x Real-Time Microcontrollers , Technical Reference Manual F28P65X Control Card and I would ...

Hello! I recently had a new work machine replaced and would like to reset or disable any installs related to the account.

exactly same as here, but no way to complete the installation.I also tried to launch orLibraryDownload from the command line, just for test. Here is the result: then, nothing happens.